>>> UHF SWEEP/SIGNAL GENERATOR <<<
Shown in Figures 1 through 6 is a UHF Generator Assembly producing 7.5 +/- 1.5 dBm at frequencies from 490 to 1060 MHz on the front panel SMA connector. See Figure 8 and 9 for frequency and power plots.
For signal and swept frequency applications, the front panel dial is used to set the center frequency (CF). To generate a swept frequency (Delta F), connection of a triangle waveform from a function generator to the GA1K back panel BNC connector is required. Click on this hyperlink, GA1K DELTA F, for additional Delta F information.
The GA1K is supplied with a 36 inch length DC power cable permanently attached for connection to the 11K18 DC power supply. See Figure 7 for details. Figure 2 shows the location on the chassis back panel of the DC power connections. +18 VDC (Green) and -18 VDC (Yellow) connect to the chassis back panel feed-thru terminals, and common ground (black) is connected to a solder lug located on the lower center of the chassis back panel.
Figure 1, Front Panel View
===
Figure 2, Back Panel View
===
Figure 3, Top View
===
Figure 4, Bottom View
===
Figure 5, Internal Top View
===
Figure 6, Internal Side View
===
Figure 7, UHF Generator and Power Supply
===
Figure 8, Output Frequency Plot
===
Figure 9, Output Power Plot
===
FOR ONLINE ORDERING, A U.S. SHIP TO ADDRESS IS REQUIRED. INTERNATIONAL ORDERING INFORMATION IS AVAILABLE BY CLICKING ON THIS HYPERLINK, INTERNATIONAL.
===